Install the transparent led film screen panel
- First, use a soft towel to wipe the edges of the panel around
- Tear off the film in front of the panel
- Use a clean soft towel to wipe the glass
- Spray purified water on the glass
- Lay on the screen and use a small scraper to dry the water off the screen.Wait for the screen to dry, you can use a towel to dry the moisture
Install power box
- The power box is divided into HUB board base (1), HUB board (2), power box back cover (3), and power box upper and lower rear cover plates (4)
- The screen has been attached to the glass and has been dried
- The first small step is to extend the socket cable of the screen at the corresponding port position.The second step is to use self tapping screws to secure the HUB board base to the door frame at the screw holes in the yellow section.
- Connect the HUB board to the corresponding wiring port of the screen.
- Secure the HUB board to the HUB board base.
- At this point, fix all HUB boards in both columns and connect all network cables first.
- Before fixing the power box, you can first secure the 5V power cord of the power supply to the HUB board to ensure that it lights up when powered on.
- Fix the back cover of the power box to the frame with self tapping screws.
- Finally, fix the rear cover plate that connects the upper and lower parts of the power box.
